Low Power Consumption Stadium Lights 300W 185LM/W Direct Swap 1000W Metal Halide IP65

This 300W floodlight is engineered for one specific situation: a ground still running 1000W metal halide lamps on old masts, where the supply capacity cannot be increased. At 185 lumens per watt, it produces 55,500 lumens from just 300 watts, so the connected load drops by roughly seventy percent and the existing cable, breaker and switchgear remain within their ratings. Mounting geometry matches common metal halide floodlight brackets, and the driver accepts 100-277 volts, enabling a straight fixture swap on the existing cross arm without rewiring the pole.

• Seventy Percent Load Cut: 300W replaces a 1000W metal halide lamp, dropping circuit current enough that old cabling and breakers stay compliant.
• 185LM/W Highest Efficiency: The most efficient platform in this range, chosen where every watt saved reduces the risk of a supply upgrade.
• Direct Swap Geometry: Bracket and housing footprint suit common metal halide cross arms, so the pole and wiring do not change.
• Wide Voltage Input: 100-277 volt input tolerates voltage sag on older rural supplies without dropping out or flickering.
• Instant Restrike: No warm-up and no restrike delay, so lighting returns immediately after a power dip instead of waiting ten minutes.
• IP65 Sealed Body: Gasketed die-cast housing protects the engine on exposed grounds while keeping weight low for old masts.
• Low Weight Design: Under nine kilograms per fixture reduces load on ageing cross arms and simplifies two-person installation.

Schools, small clubs and municipal grounds with ageing masts use this fixture when a supply upgrade is not affordable. Because the electrical load falls sharply, the existing distribution board and cable sizes usually remain valid, which removes the cost of trenching and new feeders. The instant restrike behaviour also matters on grounds where a power dip used to leave the pitch dark for ten minutes while metal halide lamps cooled and restarted. Grounds with strict weight limits on old cross arms benefit from the sub-nine-kilogram housing as well.

• School and small club grounds with old metal halide masts
• Sites where supply capacity cannot be increased
• Rural grounds with unstable voltage supply
• Ageing cross arms with weight restrictions

Each luminaire ships in a five-layer export carton with a moulded foam cradle around the optic and a separate bracket bag, palletised and strapped for container or LCL shipment. Every unit is aged, hipot tested and photometrically sampled before dispatch, and an energy audit sheet comparing LED and metal halide consumption is included for facility managers. Certification covers CE, RoHS, FCC, PSE, UL recognised components and ISO 9001 production control. Drivers, lenses and gaskets stay in stock for the full warranty term, and a commissioning guide with aiming angles and dimming profiles is supplied with each order.